Centinel C1 Security Post - probably the only security you will ever need for your vehicle, car park or driveway!

Maintenance free Base plate fits flush with the ground Separate base plates available, post can be used in different locations Keyed alike available on request Drill and pick resistant lock Locates and locks in seconds (important in bad weather!) Base fits only 18” below ground (avoiding mains cables and pipework, unlike telescopic posts!) Does not use easily attackable padlocks Accepted by all major insurance companies Stops thieves using your drive as a loading bay

The CENTINEL C1 was specifically designed as an anti-ram, anti-theft device and was developed for the purpose of protecting vehicles, premises and property, unlike folding or “telescopic” posts, both useful in deterring the opportunist thief but offering less resistance to the professional thief or direct ramming.

The CENTINEL has been in use for over a decade and proudly boasts (with client information available) a ZERO THEFT RATE. All this from a post which requires no maintenance and can be located and locked in a matter of seconds, which, if it is raining or snowing, is very important.

Ease of use
The lock is integral and fitted at the top of the post – simply locate and lock.

Peace of mind
The lock is graded CEN 5, this is the highest E.E.C. security rating, drill and pick resistant with a restricted profile key-way, this means the key cannot be copied by any other locksmith.

When you turn that key, an ingenious 10mm thick laser cut steel cam is located into what has to be the most highly engineered locking block on any security post available today. No pressure is placed on the lock itself.

Add to that, the fact that CENTINEL is the only post with a 5mm wall thickness that is fitted on the diagonal, in effect this means that in a ramming situation, CENTINEL is equal in strength to a wall thickness of over 10mm. Less weight – greater strength!

So remember, when securing your forecourt, show room window, shutter doors or driveway “it has to be CENTINEL”- the one with the proven record.

Technical Specifications:
MAIN UPRIGHT: Cold formed hollow section 60x60x5mm to BS 436D\43\A - locking rod 12mm
diameter steel to BS 970 1991 part one.
TOP SHROUD: 3mm steel, all seams fully welded, height 855mm, installed height 675mm.
LOCK: AP2000 High Security cylinder, rated CEN5 highest EEC security rating. Restricted
profile, drill and pick resistant. Cylinders can be keyed alike.
FINISH: All outside surfaces shot blasted, bottom 300mm of post protected by hot non-ferrous
metal spray to prevent rust. 2 pack etch primer applied to all surfaces. Post is then polyester
powder coated and cured at 200 degrees.